homebridge-rpi-rf-switch

rpi-rf plugin for Homebridge

Usage no npm install needed!

<script type="module">
  import homebridgeRpiRfSwitch from 'https://cdn.skypack.dev/homebridge-rpi-rf-switch';
</script>

README

homebridge-rpi-rf-switch

npm npm verified-by-homebridge

rpi-rf Plugin for Homebridge

This plugin allows you to send 433MHz RF commands via HomeKit. I had no luck getting anything other than rpi-rf to communicate with my hardware. There are other plugins though, try those if this doesn't work for you.

Installation

  1. Install Homebridge using the official instructions.
  2. Install pip using sudo apt install python3-dev python3-pip.
  3. Install rpi-rf using sudo pip3 install rpi-rf.
  4. Install this plugin using sudo npm install -g homebridge-rpi-rf-switch --unsafe-perm.
  5. Update your configuration file. See configuration sample below.

Configuration

Edit your config.json accordingly. Configuration sample:

"platforms": [{
    "platform": "rfSwitch",
    "name": "RF Switch",
    "devices": [{
        "name" : "Outlet 1",
        "on_code": 999988851,
        "off_code": 999989622
    }, {
        "name" : "Outlet 2",
        "on_code":  379952729,
        "off_code": 379953500
    }]
}]
Fields Description Required
platform Must always be rfSwitch. Yes
name For logging purposes. No
gpio The BCM number of the pin your RF transmitter is connected to. (Default: 17) No
repeat RF code repeat cycles. (Default: 10) No
devices Array of switch config (multiple switches supported). Yes
|- name Name of your device. Yes
|- on_code RF code to turn on your device. Yes
|- off_code RF code to turn off your device. Yes
|- pulselength RF code pulse length. (Default: 350) No
|- protocol RF code protocol. (Default: 1) No
|- codelength RF code length. (Default: 24) No

Note on Getting RF Codes

I've had the best luck with RFSniffer from the 433Utils project. Your mileage may vary.