pimatic-livolo

Plugin for livolo remote switches

Usage no npm install needed!

<script type="module">
  import pimaticLivolo from 'https://cdn.skypack.dev/pimatic-livolo';
</script>

README

Livolo pimatic plugin

Plugin for pimatic to support livolo remote switches. Requires 433 MHz transmitter connected to raspberry pi.

The plugin emulates livolo 433 MHz remote control, so you will need actual values for remote Id and also key codes. If you don't have those you can use these:

Remote Ids:

  • 6400; 19303; 10550; 8500; 7400

Key codes (buttons on remote):

#1: 0, #2: 96, #3: 120, #4: 24, #5: 80, #6: 48, #7: 108, #8: 12, #9: 72; #10: 40, #OFF: 106

Installation

npm install pimatic-livolo

Important: if you do not run pimatic as root your user must be a member of the gpio group, and you may need to configure udev with the following rule (assuming Raspberry Pi 3):

$ cat >/etc/udev/rules.d/20-gpiomem.rules <<EOF
SUBSYSTEM=="bcm2835-gpiomem", KERNEL=="gpiomem", GROUP="gpio", MODE="0660"
EOF

Usage

  1. Assign transmitting pin in plugin config. This plugin uses physical pin numbering so by default pin 22 is used which is GPIO25 pin for raspberry pi 3.

  2. Add a livolo remote device which is similar to standard buttons device. Assign a device a remote id (see above) and a key code to every button.

  3. Make your switches learn a newly created remote device.

Livolo plugin also supports livolo switch action to activate different buttons on a device.